Blog

Do you own a Cupti that suddenly displays "Check Battery" every time you press the power button? If so, we might be able to give you a tip that might fix the problem. The "check battery" display is intended to signal a defective battery. If your battery is old and not firing the way it should the Cupti will display "check battery" We have 3 ways to deal with this issue:1.- Replacing the battery: Make sure you are using a battery capable of a constant output of 20A and a peak outpu

There are 2 basic ways of vaping depending on how you inhale:1.- Mouth to Lung (MTL): when you inhale the vapor and hold it in your mouth before passing it to your lungs2.- Direct to Lung (DL): when you inhale the vapor straight to your lungs.The first mode (MTL) is usually how cigarette smokers inhale, and so most new vapers usually enjoy this way of vaping. In this mode, the pull or draw is made by the cheeks as opposed to the other mode where the inhalation is made by the lungs (pretty much a

These are the 5 most common causes for tanks leaking I have seen:1.- E-liquid too thin: if your e-liquid is no viscous enough for the type of coil you are using it could cause leaking. Coils that are made for “direct lung” vaping are particularly prone to leak if you use a liquid that is more on the thin side. There are 2 components of the e-liquid: PG (Propylene Glycol) and VG (Vegetable Glycerine). VG is a lot more viscous than PG, therefore the more PG your e-liquid has the thinner it will be

Every time you change the coil of your vaporizer you need to “prime” it. Priming the coil is getting the wick moistened enough so that when you take that first puff you get a nice flow of good tasting vapor instead of a disgusting burnt taste “dry hit”. There are 3 methods to prime the coil: 1.- The time and patience method:  If you read the instructions of any vaping device out there you will probably be informed to “let it sit” for 10 minutes before you start v

Your Cupti is gurgling, spitting and changing the coil does not fix the issue? It is very common to overfill the tank of the Cupti, and sometimes when doing so, some liquid will find its way to the inside of the wall of the stem and stay trapped there. We have dealt with this problem in 2 different ways. The objective is to clean the inside of the metal wall of the stem. Method #1: 1.- Unscrew the stem and unscrew the coil from the stem 2.- Open the airflow valve and wrap a napkin o