How to use the MTL Kangertech Emow Mega kit
Please read carefully before using the kit:
Your Kangertech Emow Mega Kit contains:
- 1 USB Charger
- 1 AC Wall Adapter
- Extra dual coils
- Pre-assembled Emow Mega
Let’s take a look at the parts when disassembled:
1.- Now lets start by separating (by unscrewing) the tank from the battery:
The kit comes with a "beauty ring" which is only a decorative piece. This piece can be screwed/unscrewed.
The battery (EVOD VV battery) comes pre-charged from the factory. These batteries have a safety feature that allows you to “lock” it so it will not power by clicking the button. This is good to implement when you are putting your Emow inside a pocket or in your purse.
The battery is shipped in “locked” position. To unlock it you have to press the Power button 5 times in 2 seconds. You will see the light flash 5 times.
Whenever you want to lock it again, press the button 5 times in 2 seconds.
This battery ( EVOD VV 1600 mAh) has variable voltage. At the bottom of it is a rotating ring to set the desired voltage.
We recommend you to start by setting the voltage in its lowest setting by rotating the ring all the way counterclockwise to the 3.2V setting. After you start using it you can raise the voltage until you find the setting that produces the best flavor. If you raise it too much you could burn the coil and experience a burned taste. If this happens you must discard the coil and start all over with a new coil.
2.- Now lets take a look at the tank. Start by unscrewing the base from the tank.
There is a coil already in place. Unscrew the coil from the base.
and screw it back making sure it is well screwed.
Now put the base with the coil aside and look at the inside of the tank. You will see a central tube. This central tube is where the vapor flows.
Positioning the tank upside down, fill the tank making sure not to fill above the level of the middle tube. Do not pour e-liquid into the middle tube.
Once you fill the tank, take the base (that has the coil already screwed in) and screw it to the tank.
Now screw the whole tank into the battery
3.- Now you should let the Emow rest for 10 minutes in upright position in order to allow the coil absorb the e-liquid, this is called priming the coil. There are other ways to prime the coil you could experiment later on. To find out please read our article: " 3 Ways to prime the coil"
4.- The Airflow base also has a ring that rotates to adjust the amount of air that flows in. Make sure before using it that at least 1 hole is open.
After you have let the Emow rest for 10 minutes and checked that the voltage setting is in its lowest position and that the airflow valve is open you are ready to use it. Now inhale at the same time you press the power button and vapor should start coming out. Raise the voltage level by small steps and adjust the airflow to your liking.
Other important tips:
It is always normal to see a drop of e-liquid in the battery connector when you unscrew the battery from the tank. Just dry the connector gently with a paper towel.
Remember that these vaporizers unlike cigarettes are not disposable so in order to keep the hygiene we recommend having disinfecting wipes and wipe the tip and the whole vaporizer during the day every once in a while.
This vaporizer can be left in any position (upside down, laying horizontally, etc.) and it will not leak, so you do not have to worry about how you lay it down.
Make sure to refill the tank when it is at a third of its capacity (avoid a “dry hit”) and change coils often as needed. You will notice a decrease in flavor and in the amount of vapor which will be indicative of the need to put a new coil.
You are on your way...enjoy!
Happy vaping :)